Magnetics Calculators29 instruments

PCB Spiral Inductor

Modified Wheeler formula for square, hexagonal, octagonal and circular spirals, with RF Q.

L=K1μ0n2davg1+K2ρL=\frac{K_1\mu_0 n^2 d_{avg}}{1+K_2\rho}
Fig. 1 Planar spiral trace (to scale): bridge returns from the centre on another layer
Square · n = 6d_in = 7 mm
Fig. 2 Inductance vs. number of turns for this footprint
0510152025300200400600800turns nL (nH)
L
hover / touch plot to probe
Inputs drag, tap ± or type (SI suffixes ok: 4k7 → 4.7k)
Shape
mm
mm
mm
oz
Hz
Results
Inductance
583.4 nH
dind_{in}
7 mm
Fill ratio ρ\rho
0.263optimal hollow zone 0.25–0.55
Trace length
217.2 mm
DC resistance (20 °C)
431 mΩ
Q-proxy L/RL/R
1.35 µs
Dimensionless Q
115XL at 13.6 MHz

§ How it works

Mohan, Hershenson, Boyd & Lee (1999) refined Wheeler's solenoid fit for planar spirals. The modified Wheeler expression is accurate to a few percent for typical PCB and RFIC inductors:

L=K1 μ0 n2davg1+K2 ρ,davg=dout+din2,ρ=dout−dindout+dinL = K_1\,\mu_0\,\frac{n^2 d_{avg}}{1 + K_2\,\rho},\qquad d_{avg} = \frac{d_{out}+d_{in}}{2},\qquad \rho = \frac{d_{out}-d_{in}}{d_{out}+d_{in}}

with K1,K2K_1, K_2 = (2.34, 2.75) square, (2.33, 3.82) hexagon, (2.25, 3.55) octagon. The inner diameter follows from the geometry:din=dout−2nw−2(n−1)sd_{in} = d_{out} - 2nw - 2(n-1)s.

The fill ratio ρ\rho tells you how "hollow" the spiral is. Inner turns are short and have opposing current on the far side, so they add little inductance but lots of resistance; hollow spirals (ρ≈0.3–0.6\rho \approx 0.3–0.6) give the best Q. DC resistance uses copper resistivity 1.72×10−8 Ω m1.72\times10^{-8}\,\Omega\,m and 1 oz ≈ 35 µm thickness; at RF, skin effect raises it further.